|
Post by ddany54 on May 15, 2020 17:19:51 GMT
Hello ! I recently switched Discover Media 2016 to Discover Pro 2018. I removed component protection, activated all Swap codes, also did all coding (comparing adaptations and long coding with in previous MIB2 media) and currently car is bug free at obd level. My problem comes with the volume. When I start the car, it sounds good, but when I press the mute button, switch source or enter navigation voice, it limits the volume to about 50%, leaving it limited and distorted, without raising it again. The bar shows that it is at maximum, but at an audible level it is clear that it is not. Reboot and the problem is fixed. I have tried everything but cannot resolve the error. Do you know this problem? Thanks
|
|
|
Post by vwjap on May 15, 2020 22:01:33 GMT
Upgrade the firmware?
|
|
|
Post by ddany54 on May 16, 2020 16:01:11 GMT
Remove component protection and already tell the problem, Upgrade to the latest firmware version before configuring Swap codes, adaptations and long coding but everything stays the same and I'm afraid that if I restore the firmware again I lose all Swap codes. it's rare for everything to go well and only problems when I press mute (the old mib had no mute), sound the navigation voice or switch source. thanks anyway
I'm thinking of installing dynaudio in case the problem was hardware and it was fixed by pulling out the sound for another stage.
|
|
|
Post by dv52 (Australia) on May 16, 2020 22:13:22 GMT
^^^^ how did you remove component protection - did you use a FASZIT connection?
Don
|
|
|
Post by ddany54 on May 17, 2020 19:30:15 GMT
I took him to a workshop to carry out the process. They promised me that no function would be lost but it did not happen and I had to find information to activate everything. I think they used ODIS but I do not know what type of connection. You are not the first to it tells me it could be due to the process of removing CP. What kind of processes / programs / connections are there? Thank you
|
|