Post by natlol on Aug 2, 2022 19:13:21 GMT
Hi all, have been using the NextGen Device for a few years roughly on IOS. Really pleased with the device and it has really helped me with retrofitting items to my 2016 Skoda Rapid. I have some general questions about the app that have recently puzzled me.
The first is the "Change Service Mode". In the past I have coded fine in the default mode which is VW- Diagnostic Mode. I have long coded the Light assistant etc. I have been trying to enable hill hold on my car but keep getting incorrect sequence when I do this on the ABS module. Someone has told me I need to change the mode.
I had a look and have these choices:
-OBD-diagnostic mode
-Programming Mode
-VW Diagnostic Mode
-Diagnosis mode for safety systems
-End of assembly line mode (EOL)
-I/O
-Development Mode.
I was told to use either EOL or Development mode. Under EOL It says that long coding is unavailable. Under Development mode it says Access authorization required perform Login. (I presume my security code is invalid?)
I decided to try the programming mode one and as soon as I pressed it the car started beeping and errors started flashing on the dash like airbag fault etc. I disconnected ODBEleven went back in and cleared lots of errors and the car in running fine. I didn't dare try doing any coding in that mode after that.
Can anyone shed any light on what the modes are and which I need to longcode the ABS pump or should it work like the other modules with VW-Diagnostic mode.
Thanks for any help
Nath
The first is the "Change Service Mode". In the past I have coded fine in the default mode which is VW- Diagnostic Mode. I have long coded the Light assistant etc. I have been trying to enable hill hold on my car but keep getting incorrect sequence when I do this on the ABS module. Someone has told me I need to change the mode.
I had a look and have these choices:
-OBD-diagnostic mode
-Programming Mode
-VW Diagnostic Mode
-Diagnosis mode for safety systems
-End of assembly line mode (EOL)
-I/O
-Development Mode.
I was told to use either EOL or Development mode. Under EOL It says that long coding is unavailable. Under Development mode it says Access authorization required perform Login. (I presume my security code is invalid?)
I decided to try the programming mode one and as soon as I pressed it the car started beeping and errors started flashing on the dash like airbag fault etc. I disconnected ODBEleven went back in and cleared lots of errors and the car in running fine. I didn't dare try doing any coding in that mode after that.
Can anyone shed any light on what the modes are and which I need to longcode the ABS pump or should it work like the other modules with VW-Diagnostic mode.
Thanks for any help
Nath