|
Post by rste89 on Dec 10, 2020 13:17:13 GMT
Hi, I am trying to figure out how to slam my A6 Allroad in obd eleven pro for car shows/photoshoot etc, not for driwing and after that reset it back to default for driwing. Please if you know, write steps or where should I start. Probably in long coding how to do it etc.
|
|
|
Post by a6allroad on Mar 1, 2021 23:02:23 GMT
Hey did you have any luck with this? Want to do the same to mine
|
|
|
Post by kevtrem on Mar 9, 2021 19:08:34 GMT
Its easy to do but is slow, I do it with my Allroad.
In your control units look for chassis control (34), Basic settings Vent front axle Go (wait for it to complete) Vent rear axle Go (wait for it to complete)
That will be the car sat on bump stops, now when you start the car it will throw a couple of warnings about the suspension being too low to drive. Go into CAR menu on the MMI, driver aids, the untick jacking mode, the will raise the car to the level you normally have it set at. Before venting the axles make sure steering is straight, it will only vent both axles if front is selected first. It will vent the axles with the ignition on, you do not need the engine to be running.
|
|
|
Post by kleinjim on Jun 18, 2022 21:35:44 GMT
The jacking mode do you already activate it before venting?
|
|