|
Post by peylix on Jun 20, 2020 22:03:54 GMT
Hello all. I recently installed an IS38 on my 2015 GTI SE. However the wastegate needed to be adjusted. It was reading 4.5v and gave me the P256300 error / EPC light. So I got under the car, and readjusted the actuator arm until the voltage reading was down to 3.5v. All that's left is to adapt the wastegate to the new voltage. This can be done through Basic Settings > First Adaptation of Charge Pressure Actuator. However when I go to do this. OBDeleven errors out with (13) function cannot be performed, mess, length or format incorrect
Does anyone have any insight as to why or a fix to this?
Thanks
|
|
|
Post by dirtyhary91 on Jul 16, 2020 12:07:01 GMT
Hello all. I recently installed an IS38 on my 2015 GTI SE. However the wastegate needed to be adjusted. It was reading 4.5v and gave me the P256300 error / EPC light. So I got under the car, and readjusted the actuator arm until the voltage reading was down to 3.5v. All that's left is to adapt the wastegate to the new voltage. This can be done through Basic Settings > First Adaptation of Charge Pressure Actuator. However when I go to do this. OBDeleven errors out with (13) function cannot be performed, mess, length or format incorrect
Does anyone have any insight as to why or a fix to this?
Thanks
Hi, have you solved the problem? Im in the same situation at this moment. the procedure to adjust the wastegate is also not clear to me. I wonder if you have succeeded in getting the correct adjustment. Greetz Danny
|
|