|
Post by gianry on Feb 15, 2020 19:52:11 GMT
on my previous discover pro mib1 I've enabled the speed limit sign display... now I don't remember the right coding to enable that on mib2 unit
Could you help me ?
thanks
|
|
|
Post by gianry on Feb 15, 2020 20:33:52 GMT
I don't think it is the right coding... I remember only a code on Discover pro
I haven't the front camera
|
|
|
Post by dv52 (Australia) on Feb 15, 2020 22:19:26 GMT
^^ try setting Byte 24, Bit 6 (it's labelled "vza") on the hex5F module - then reset the MIB Don
|
|
|
Post by dv52 (Australia) on Feb 16, 2020 0:09:22 GMT
^^ try setting Byte 24, Bit 6 (it's labelled "vza") on the hex5F module - then reset the MIB Don
Hi
I thought I was asking about the speed alerts in the FIS
VZA = On, the speed limit signal appears in the upper left of the infotainment screen, if you have a browser.
Greetings.
Adrian: I was answering this: on my previous discover pro mib1 I've enabled the speed limit sign display... now I don't remember the right coding to enable that on mib2 unit Could you help me ? thanks
And this: I don't think it is the right coding... I remember only a code on Discover pro I haven't the front camera
which was gianry's response to your reply: Hi
Hex 17 Control Unit - Instrument Panel - Adaptation - Speed Warning = Active + XXX km / h
- Extended Coding - Speed warning = ON / OFF
Greetings.
So this entire thread (which was started by gianry) is about speed limit sign display (see first post) - not sure how you were "asking about the speed alerts in the FIS" to @gianty question?
Don
|
|
|
Post by gianry on Feb 16, 2020 8:14:50 GMT
I'm asking about speed limit in discover display , not FIS
|
|
|
Post by gianry on Feb 16, 2020 16:05:40 GMT
^^ try setting Byte 24, Bit 6 (it's labelled "vza") on the hex5F module - then reset the MIB Don Yes , this is the code Always the best !
|
|