|
|
Post by kranks4567 on Apr 5, 2019 4:08:34 GMT
Hi, I installed new exhaust muffler and getting fault code, tried to check and u check module 1 unit 9 bit 1 or 2 tick and untick for exhaust flap install yes or no. But still getting fault code on it. Valve stays open and unable to operate it to close using by drive select. Any advice or suggestion will be much appreciated. Thanks in advance.
|
|
|
|
Post by eagle4 on Apr 19, 2019 7:36:00 GMT
hello, the valve always remains open at idle, it only works depending on the load on the engine. Here is a subject that I completed with a video. In French sorry !! Valve |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 26, 2019 15:31:15 GMT
valve doesn't work like the bit says...it'll change its position depending on the engine load even if you deactivate its bit...so the better solution is to unplug the connector but you'll always have the exhaust flap error..nothing important though
|
|
