|
Post by frank22 on Feb 21, 2023 22:30:43 GMT
Hallo,
ich habe "Autocode Gateway List" codieren lassen. Jetzt habe ich einen Fehler im Steuergerät "Diagnoseinterface für Datenbus" > Fehlermeldung: "Mehrverbau erkannt" Diese Fehler lässt sich auch nicht löschen.
Frage wie kann ich die Codierung von "Autocode Gateway List" rückgängig machen?
Wieso wird so ein Mist überhaupt bei OBD11 angeboten.
ich danke euch.
Gruß Frank
|
|
|
Post by dv52 (Australia) on Feb 21, 2023 23:34:48 GMT
Frank: hmm........I'm surprised - normally Autocode works well!
The procedure for Autocode is included below (authored by my colleague)
However, I suspect that simply disabling Autocode WON'T solve your problem. You really need to fix the unregistered modules on the Gateway List!
Why has this fault appeared - what's the back-story for this problem (have you added new modules)?
Don
the autocode process can be found here cupra280.co.uk/obd11.html#AutocodeHowever to make it easier 1/ From the Main menu select Settings
| 2/ From Settings Menu ensure Autocode Gateway List is set to show, if not change it to show
| 3/ Connect to car and you should get the following popup box , Select Yes and any missing control units will be ADDED
| | | |
if the popup box does not arrive I suspect the autocode process does not think you are missing any control units. Once you have selected the control unit double check the status of it (if the number is in a Black Circle then its not being picked up as a live control unit by OBD11)
|
|