|
Post by tarekwezo on Aug 24, 2021 0:24:34 GMT
Hello, My car has been red flagged and they might discard its warranty because they found some coding and adaptations last time when i went to the service center. Is there anyway to delete the history of the control module as they found this last time from the can module history? They are using the original VAG of course and they have known that thia car has been modified by obdeleven I need to to delete the coding without them knowing that i have connected and obd plug .
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 24, 2021 9:16:37 GMT
Honest answer is I do not know.
However as far a my limited knowledge goes you can only change stuff one of three ways.
1/ Using the cars in built menus
2/ Using third party tools like obd11 3/ Removing the control unit and using specialist tools to make changes (but they do leave traces)
Normally if the garage has found changes they (certainly in uk and spain) only red flag that component but not the whole car although obviously when you make a claim they will pay extra attention.
Sorry I cant help more.
|
|
|
Post by tarekwezo on Aug 24, 2021 9:55:43 GMT
They are paying extra attention with me anyways What I’m asking about if I go and revert these changes back from history , will they know that these changes have been made and when they have been made ?
Thanks
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 24, 2021 10:18:36 GMT
Again dont know but if you are talking about reverting the changes you made to cause the red flag in the first instance then I suspect there is nothing you can do. I would expect that your VIN Number will have been marked on central systems (but I do not know for sure) so even though they now match factory spec they will still have a record you made the changes.
Sorry that dont answer your question.
|
|