|
Post by voskoboinikov on May 15, 2021 16:57:18 GMT
Hello. I have installed a rear view camera in my car. I coded it, everything works, but there is an error in the camera block that the basic installation has not been performed. In ODIS, as far as I know, to calibrate the camera, it is enough to enter only three values - the height of the stand, the height from the ground to the camera and the distance from the rear wheel axis to the calibration stand. In OBDeleven, when trying to perform a basic installation, you need to enter significantly more values. My English is very bad, so I ask you to suggest which parameters should be measured and filled in in the following points of the program. My car is Skoda Kodiak 2020 m.y. Thanks in advance disk.yandex.ru/i/CJ2evkTHQovsgAdisk.yandex.ru/i/oF19BCB2Dm30Tg
|
|
szlat
New Member
Posts: 1
|
Post by szlat on Dec 7, 2021 11:33:44 GMT
Did you solved your problem? How?
|
|
|
Post by voskoboinikov on Dec 12, 2021 15:06:19 GMT
No. Received the calibration data read using this application from the car on which the camera is installed from the factory. But this did not help much until I figured out how to apply it for myself.
|
|
ckgth
New Member
Posts: 1
|
Post by ckgth on Sept 29, 2023 8:07:33 GMT
Hi,
is there a way to (re)calibrate the Rear View camera over ODBeleven? How? My Cam is a little blurred on the Display , but no Hardware-Issue. Cam it self is clear.
thank you Christian
|
|