|
Post by phoinix on Dec 15, 2019 21:32:19 GMT
Hello *,
Tried disabling Start/Stop Function, with the temperature way:
- Select Control unit 19 - Adaptation - EM_start_stop_requirement_ambient_temperature - Minimum_temperature - Set to 50c The coding is not supported in my car.
Tried disabling Start/Stop Function, with the voltage way:
1 - Module 19 - diagnosis interface for data bus. Code (20103) 2 - Adaptation 3 - Select - Limit Initial voltage Start / Stop 4 - Change value of 12 V. Default 7.6 V
Start/Stop is disabled momentarily, but after a while it is re-enabled automatically.
Tried disabling Start/Stop Function, with the Adaptation channel:
CAN Gateway Adaptation DEACTIVATION OF START STOP FUNCTION STOP PROHIBITION NO START REQUEST
(Available options) : MODE NOT ACTIVE (default) STOP RELEASE STOP PROHIBITION NO START REQUEST START REQUEST Start/Stop is disabled momentarily, but after a while it is re-enabled automatically.
Has someone had any success with this for MY2019 Model?
Thanks
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 15, 2019 23:00:38 GMT
maybe they have made a change to stop this.
Following may be of interested if you have a Cupra.
Except in the CUPRA model. In this case, when you place the selector lever in the S position or in the Tiptronic mode, the Start/Stop system will prevent the engine from switching off.
|
|
|
Post by phoinix on Dec 16, 2019 9:01:16 GMT
This is a 1.5TGI Leon. Wished it was a Cupra I will try the method proposed in the thread: 1.- You start app and connect to your car. 2.- Engine electronics. 3.-Adptation. 4.-The last option.- activation of the start / stop function.
And revert Thanks @testeronline
|
|
|
Post by phoinix on Dec 16, 2019 19:40:30 GMT
Tryied the above The coding is accepted, and I get a "Start/Stop System malfunction" in the MFD, but after a while it is re-enabled automatically. Bummer Any suggestions are welcome. That thing resists dying
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 16, 2019 22:27:53 GMT
I have seen a few threads recently that imply that VW Have done something that stops this code working now (Newer cars).
Its not confirmed but on a few forums people are complaining it don't work.
Personally I bought myself a memory chip that recalls the last setting the stop start button was set at so its always turned off until I turn it back on again.
You can buy these on ebay or build your own if you are technically minded.
not yet seen a coding solution i am afraid
|
|
jaco2k
Closed beta tester
AWD FTW!
Posts: 63
|
Post by jaco2k on Jan 6, 2020 14:14:25 GMT
Doesn't help here, but I have managed to disable it on my girlfriend's car (Ibiza 1.5tsi) from year 2018 with the voltage method, so this change is pretty recent.
|
|