|
Post by bvisgreat on May 8, 2019 20:26:54 GMT
I see posts about doing this with VCDS but what about using OBDELEVEN?
|
|
|
Post by krystian660 on May 9, 2019 6:56:37 GMT
You can do this like in VCDS.
|
|
|
Post by bvisgreat on May 28, 2019 23:58:12 GMT
You can do this like in VCDS. Show me module 34 and the basics menu outside of adaptation.
|
|
|
Post by skarecrow on Jun 14, 2019 7:55:04 GMT
Did you find out exactly how to do this? I'm interested in lowering the A8 also but wasnt able to find a step by step using long coding. And I see a lot of videos out there but nothing on how to use long coding with the Audis. If I find out, i will make one.
|
|
swen
New Member
Posts: 1
|
Post by swen on Aug 9, 2019 16:58:26 GMT
Has anyone had success recalibrating the height of the car. When i try to enter a measurement value, it says incorrect sequence.
|
|
aly
New Member
Posts: 1
|
Post by aly on Dec 10, 2019 21:41:43 GMT
Lowering Suspension Procedure for Audi D4 A8/S8 (taken from VCDS amended for OBD11 in simple terms)
1. Turn ignition ON 2. Set Comfort Mode 3. Raise 4. Set Auto Mode 5. Lower (keep doors closed) 6. Find Module 34 and open 7. Adaptation--write down each value for LF, LR, RF, RR 8. Security Access 20103 9. Fire Engine up 10. Basic Settings-- Activate Level Control 11. Basic Settings-- Delete Calibration Level Control 12. Basic Settings-- Start Up to Reference Level 13. Adaptation-- add xxmm to each corner to lower it by that much (LF, LR, RF, RR) 14. Basic Settings-- Calibrate Level Control 15. Basic Settings-- Activate Level Control 16. Optional-- Full Scan and clear fault codes
|
|