|
Post by techserv on Jul 22, 2018 6:03:23 GMT
I have a Audi A6 Quattro 2.7T,I recently purchase OBDeleven to troubleshoot check engine light and abs light. Useful tool to determine the cause for failure wasn't open or shorted right wheel sensor. I replaced the sensor and tested the take off magnetic coil and switching was fine open /close ,verified reluctor was ok. Moving forward I tested during live data and found abs module was dropping out after 20 kmph. Replaced abs module and now OBDeleven will not let me update the coding for this device. Does anybody have any suggestion.Note the old coding and new coding in the image.
|
|
|
Post by techserv on Jul 24, 2018 1:51:17 GMT
So rather then tell evryone not to respond to me. Why didn't you tell me what blog/thread to ask my question. I need help with your app. No write capability, or does it have. I need your feedback. Thanks
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jul 24, 2018 8:44:24 GMT
techserv firstly to be clear this is a USER forum that is provided by OBD11 not a OBD11 Support site so I am afraid you have to rely on other users.
I personally would post this question in your car's thread as you are more likley to get the attention of an Audi A6 Owner who has done this.
Never had to change hardware on my car so afraid cant offer any advise other than the usual have you cleared you app cache on the android device and tried again and or have you changed diagnostic mode - dont expect either of those will make a difference but its the standard ctrl alt delete process.
Lastly i am guessing that the device still thinks you have the old ABS system attached hence when you try and update it it does not work, again I am afraid I have not added new hardware but if you search through the forums I am sure somebody has shown how to do this, DV52 does a lot of work on this forum and may have documented this process for a Golf MK7.
Sorry cant help you more than that.
|
|
|
Post by sirkay on Jun 29, 2019 23:55:06 GMT
Hi, was there a solution found for this? I need to program my abs control module too.
|
|